Get 2025 Updated Free AVIXA CTS-D Exam Questions and Answer
CTS-D Dumps PDF and Test Engine Exam Questions
NEW QUESTION # 36
Which of the following is a primary function of a DSP in an AV system?
- A. Power supply regulation
- B. Signal amplification
- C. Signal distribution
- D. Signal processing including filtering, mixing, and delay
Answer: D
NEW QUESTION # 37
Which of the following are associated with sound pressure levels?
(Select all that apply.)
Response:
- A. Is the ultimate method for quantifying background noise levels
- B. Eliminates distortion in speech reinforcement
- C. Is typically measured in decibels (dB SPL)
- D. Can most accurately be measured with a Class 0 precision SPL meter
Answer: C,D
NEW QUESTION # 38
Which type of connector is commonly used for digital audio over coaxial cable?
- A. USB
- B. RCA
- C. XLR
- D. HDMI
Answer: B
NEW QUESTION # 39
Which of the following cable types is most suitable for audio signals that require noise rejection?
- A. Unshielded twisted pair (UTP)
- B. Coaxial cable
- C. Shielded twisted pair (STP)
- D. HDMI cable
Answer: C
NEW QUESTION # 40
Which of the following best describes an "amplifier" in an audio system?
- A. Device that switches video signals
- B. Device that mixes audio signals
- C. Device that increases the power of audio signals to drive speakers
- D. Device that converts analog signals to digital
Answer: C
NEW QUESTION # 41
An AV integrator's documentation that includes scope of work, definition of systems, and responsibilities should be defined in which of the following documents?
Response:
- A. Commissioning punch list
- B. Schematic design narrative
- C. Systems specification
- D. Project submittals
Answer: C
NEW QUESTION # 42
What is the primary purpose of an AV system "site survey"?
- A. To finalize budget
- B. To conduct user training
- C. To install equipment
- D. To assess physical space and infrastructure constraints and opportunities
Answer: D
NEW QUESTION # 43
When you've identified a security risk, you can avoid it, accept it, transfer it, or __________.
Response:
- A. Change it
- B. Reconfigure it
- C. Eliminate it
- D. Mitigate it
Answer: D
NEW QUESTION # 44
What is a common method to reduce electrical noise in AV systems?
- A. Using unshielded cables
- B. Proper grounding and shielding
- C. Increasing cable length
- D. Ground loops
Answer: B
NEW QUESTION # 45
If a font height is 2 in (50 mm), the screen height is 60 in (1,525 mm), and screen resolution is 1080 pixels high, what is the font size in pixels?
Response:
- A. 40 point
- B. 36 point
- C. 28 point
- D. 32 point
Answer: B
NEW QUESTION # 46
How does one define project responsibilities and identify AV technology requirements?
Response:
- A. Follow guidelines determined by state and local building codes
- B. The project manager will outline the responsibilities in the RFP
- C. Consult with the owner as the project progresses
- D. Follow the project directory & program report
Answer: D
NEW QUESTION # 47
Which of the following best describes a "block diagram" in AV design?
- A. Installation steps
- B. Room layout
- C. High-level signal flow and equipment interconnections
- D. Detailed wiring connections
Answer: C
NEW QUESTION # 48
Which AV standard primarily deals with high-definition multimedia interfaces?
- A. VGA
- B. USB
- C. HDMI
- D. RS-232
Answer: C
NEW QUESTION # 49
During the design phase of a project that has many network-enabled AV devices. What will the IT team need from the AV designer?
Response:
- A. Device operating systems
- B. Device serial numbers
- C. Device list of non-networked AV equipment
- D. Device bandwidth requirements
Answer: D
NEW QUESTION # 50
What is the benefit of using an IP-based AV system?
- A. Requires proprietary hardware
- B. Increases latency
- C. Simplifies cabling by utilizing existing network infrastructure
- D. Reduces video resolution
Answer: C
NEW QUESTION # 51
What should be included in the AV specifications to further describe the system components?
Response:
- A. Codes, references, shop drawings, commissioning & testing requirements
- B. Ergonomics, RF and IR reception, heat loads, signal separation
- C. Connector types, amount of conduit used, signal path
- D. Equipment manufacturer, serial number, number of USB ports
Answer: A
NEW QUESTION # 52
Which of the following describes a "floor plan" in AV design?
- A. A diagram showing signal flow
- B. A drawing showing the physical layout of equipment and furniture in a space
- C. An installation checklist
- D. A budget document
Answer: B
NEW QUESTION # 53
What is the term for a graphical representation of signal flow between system components?
- A. Wiring diagram
- B. Block diagram
- C. Floor plan
- D. Gantt chart
Answer: B
NEW QUESTION # 54
Which is a typical function of an AV control processor?
- A. Routing audio signals
- B. Amplifying audio signals
- C. Powering displays
- D. Centralized control and automation of AV devices
Answer: D
NEW QUESTION # 55
In an AV system, what is the main benefit of using a matrix switcher?
- A. To amplify video signals
- B. To convert signals from analog to digital
- C. To increase audio power
- D. To route multiple inputs to multiple outputs flexibly
Answer: D
NEW QUESTION # 56
What details should be included in the AV system Design Package?
Response:
- A. Grounding and Signal, Network Panels and Lighting
- B. Network Panels, Fire/Life Safety and Power
- C. Fire/Life Safety, Network and Furniture Integration
- D. Furniture Integration, Custom plate and Panel, Power, Grounding and Signal
Answer: D
NEW QUESTION # 57
What does the term "gain before feedback" refer to in audio system design?
- A. The maximum amplification before the system produces feedback noise
- B. The difference between input and output signal strength
- C. The maximum volume before distortion occurs
- D. The increase in amplifier power over time
Answer: A
NEW QUESTION # 58
An organization needs its own DNS server if it __________.
Response:
- A. Needs to statically associate certain names and IP addresses
- B. Needs to access the Internet
- C. Uses DNS internally to manage the names and addresses of devices on the private network
- D. Has more than one LAN
Answer: C
NEW QUESTION # 59
......
AVIXA CTS-D Exam Certification Details:
| Sample Questions | AVIXA CTS-D Sample Questions |
| Exam Code | CTS-D |
| Passing Score | 350 / 500 |
| Number of Questions | 135 |
| Duration | 180 mins |
| Exam Name | AVIXA Certified Technology Specialist - Design (CTS-D) |
| Schedule Exam | Pearson VUE |
| Non-Member Exam Price | $575(USD) |
| Books / Training | Candidate Handbook |
Verified CTS-D exam dumps Q&As with Correct 152 Questions and Answers: https://pass4sure.dumptorrent.com/CTS-D-braindumps-torrent.html